Stand Details – Torque-Expo Exhibitor Manual

Shell Scheme Specification

Stand height is 2500mm from the floor to the top of the stand.
Maximum internal height is 2430mm to allow for the ceiling grid structure.
The white Foamex wall panels are 2350mm high x 970mm wide.
The maximum visible area of the wall panels are 2340mm high x 950mm wide.
If printing graphics to overlay on the existing wall panels the graphics should be 2340mm x 950mm, and should be fixed to the panels using one of the approved methods listed below.
If printing graphics onto Foamex to replace the existing wall panels then the Foamex should measure 2350mm high x 970mm wide x 3mm thick, and the artwork should be 2340mm x 950mm.

PLEASE NOTE: IF PRINTING WALL PANELS THE REAR OF THE PANEL NEEDS TO BE PLAIN WHITE AS THIS WILL BACK ONTO ANOTHER STAND.

Example of a 3m x 2m stand

Please observe the following do’s and dont’s to avoid chargeable damage to the system.

Nails,

Screws

Pins

Staples

Paint

Anything with a strong adhesive

Double sided tabs

Self-adhesive velcro hook and loop

Panel brackets